Error! Not a valid filename.

Adjustments

Above is my first draft printout.

The sheet of paper is the size of a greeting card.

The material “This is fake text” seems to be a little too high up the card to correspond to the pre-printed greeting on the card.

I carefully ruled a line across the text to show where the pre-printed text impinges on my variable text.

I need to lower (send further towards the bottom of the page) the column alignment. It needs to be 1.25 cm lower.

That seems to me to be the equivalent of two of my paragraphs.

So instead of seeing a paragraph numbered “26” immediately before my fake text, I need two columns by two more paragraphs, 4 extra paragraphs.

I aim to see paragraph “30” immediately before my fake text.

This is looking pretty good.

Remember that after I’ve replaced my fake text with real text, I can still fine-position the graphic on the card.

Ignore the blue lines; they are part of the scrap paper I’m using.

Looks pretty good, if I say so myself.

I set the color to be 100% fill with white, and pray that I don’t run out of white toner!

And here is my first sample run.

Not too bad.

I have to fix the smudging problem, and do a better job of feeding the card-stock so that it prints in alignment.

Merry Christmas!

Search